Need help?Do you have a question about the VINCENT SV-737 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Frequency Response | 10 Hz - 50 kHz +/- 0.5 dB |
| Input sensitivity | 300mV |
| Input Impedance | 47 kOhm |
| Outputs | 1 x RCA |
Leave maintenance to professionals. Product use restricted to AC 230V/50Hz. Alterations void warranty.
Always pull the plug, not cable. Avoid crushing or damage. Do not touch with wet hands.
Details on TREBLE, BASS, VOLUME, INPUT SELECTOR, POWER, SPEAKERS, PHONES, WPS buttons and LEDs.
Details on INPUT, DIGITAL IN, PRE/MAIN, REC OUT, SPEAKER terminals, AC INLET, POWER CONTROL, VOLTAGE SELECTOR, WIFI/BT ANT.
Remove PRE/MAIN bridges (16) to use SV-737 as power amp. Connect external preamplifier to MAIN IN.
Remove PRE/MAIN bridges (16) to use SV-737 as preamp. Connect external power amp to PRE OUT.
Device has a voltage switch (21) for 230V/110V. Switch only when off, preferably by a technician.
Connect devices for remote switching via 3.5mm jack plugs. System allows daisy-chaining for multiple devices.
Do not interconnect preamp/amp power control sockets. Receiving devices must not connect to more than one source.
Connect one or two pairs of speakers. Ensure correct polarity for positive/negative terminals.
Use POWER button (8). No standby. Unit is internally separated from AC power when off.
Check mains cable connection and insertion. Verify unit fuse or contact dealer if unit is defective.
Check source signal, player settings, correct input connection, volume, mute status, and speaker cables.
Check source signal, cable connections, and speaker cable connections. Ensure correct speaker wiring.
Check cable tightness, connector cleanliness, tone settings, and ensure phono input for record players.
Check batteries, line-of-sight, range, and angle. Ensure unit is switched on.
To Next Page
