15
Horizontal tracks
No dismantling is necessary to clean the horizontal tracks. Proceed as follow:
Remove the payload (if fitted).
Set the balance mechanism to its maximum setting by pushing in the knob (14) and turning
it clockwise to its stop.
Tilt the platform fully backwards and apply the tilt brake (5).
Pull down the flap guard (24) to reveal the bevel gear (23). Access to the horizontal tracks
is through the holes in the bevel gear, which may be rotated freely.
Using a pipe cleaner (or similar) moistened with an isopropanol-based cleaner (3M VBH or
similar), clean the two horizontal tracks. Upwards pressure on the balance mechanism will
allow the area of track under the horizontal rollers to be cleaned.
Release the flap guard (24) and the tilt brake (5) and return the platform to the horizontal
position.
Refit the payload (if required).
To Next Page
Loading...
