ViOL SYLFIRM X - Information on EMC; Electromagnetic Emissions

SYLFIRM X User Manual(VO-UM-SFX-01)
Rev. 01 Rev. date: 2020-03-16
Uncontrolled When Printed
All Rights Reserved © 2014. VIOL Co., LTD.
Page 30 of 33
Chapter 6. Information on EMC
6.1 Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
- The EUT is intended for use in the electromagnetic environment specified below. The
customer or the user of the EUT should assure that it is used in such an environment.
Immunity test Compliance Electromagnetic environment - Guidance
RF Emissions
CISPR 11
Group 1
The EUT uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment
RF Emissions
CISPR 11
Class A
The EUT is suitable for use in ail establishments, including
domestic establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes
Harmonic
emissions
IEC 61000-3-2
Class A
Voltage
fluctuations /
Flicker emissions
IEC 61000-3-3
Complies