VIOMI V2 max User Manual

How to Use
While the vacuum-mop is running, press any buon to pause it, then press the buon to resume cleaning. Pressing the buon will end the current
cleaning task and send the vacuum-mop back to the charging dock.
Pausing
When the vacuum-mop is on the charging dock, it will automatically turn on and cannot be turned off.
To manually turn on the vacuum-mop, press and hold the buon until the indicator lights up. When the vacuum-mop is in standby mode and not on the
charging dock, press and hold the buon to turn it off.
Turning On/Off
Turn the vacuum-mop on, then press the buon . Depending on the accessory installed, the vacuum-mop will automatically begin vacuuming or
mopping.
Cleaning
Turn the vacuum-mop on, then press the buon to send the vacuum-mop to the dock to recharge.
When the vacuum-mop completes the cleaning task, it will automatically return to the dock for recharging, and the indicator is blinking yellow.
If the vacuum-mop starts running low baery during a cleaning task, it will automatically return to the charging dock to recharge. Once the vacuum-mop
is fully charged, it will resume cleanup where it le off.
If the vacuum-mop automatically shuts down due to low baery, manually place it onto the charging dock, and make sure the charging terminals have a
good contact.
Recharging
If the vacuum-mop encounters an error during operation, the indicator will blink red and you will hear a voice alert. To check for a solution, please refer to
the Troubleshooting section.
If no action is taken within 5 minutes, the vacuum-mop will automatically enter sleep mode.
Fault Status
The vacuum-mop will automatically enter sleep mode aer 5 minutes of inactivity. To wake it up, press any buon or use the app.
• The vacuum-mop will not enter sleep mode while on the charging dock.
• The vacuum-mop will automatically turn off aer being in sleep mode for 12 hours.
Sleep Mode
If you need to add more water to the vacuum-mop or clean the mop during a cleaning task, press any buon to pause the vacuum-mop, then remove the
water reservoir. Aer adding water or cleaning the mop, reinstall the water reservoir and mop, then press the buon to resume the cleaning task.
Adding Water or Cleaning Mop During Cleaning
08

VIOMI V2 max Specifications

General

Brand	VIOMI
Model	V2 max
Category	Vacuum Cleaner
Language	English