VIOMI V3 Max User Manual

17
Voice Prompts Solution
The right wall sensor is blocked. Please
wipe it.
The power is too low, and the system
is about to shut down automatically.
Please charge it.
The machine is too close to a
restricted area during starting. Please
relocate it to start.
The recharge sensor is covered by
dust. Please wipe it.
The machine is tilted during startup.
Please put the machine on the
horizontal ground to start.
Please install the 2 in 1 water tank and
filters back, and make sure that filters
and the 2 in 1 water tank are installed
in place. Then please restart the
machine.
The pressure sensor for laser cover is
pressed or stuck. Please relocate it to
start.
Low power and power
off.
Please confirm whether
the recharge sensor is
blocked.
Please move the
vacuum-mop to a level
surface and start again.
Please make sure the
2-in-1 dust compart-
ment with water tank
has been installed.
Please start it up again
away from the restricted
area.
The radar cover is
squeezed.
The laser distance sensor is stuck by
foreign maer. Please clear it.
Please confirm whether
the laser distance sensor
is stuck or entangled.
Please wipe the wall
sensor in the right side.
FAQ
Voice Prompts Solution
The side brush may be entangled with
foreign maers. Please clean and
restart it.
The collision sensor is stuck. Please
tap repeatedly to remove foreign
maers. If there is no foreign maer,
please relocate it and then start it.
The machine may be suspended.
Please relocate it and start. If the cliff
sensor is too dirty, it may also cause
the fault. Please wipe the cliff sensor
to eliminate the fault.
If any wheel is stuck, please check
whether any foreign maer is stuck in
the wheel, or move it to near its home
position to start it.
The rolling brush may be entangled
with foreign maers. Please remove
and clean it, its connections, its cover
and the suction inlet.
The machine is trapped. Please clear
obstacles around.
A wheel is suspended. Please move it
to near its home position to start it.
Please check and
remove any foreign
maer from the
collision sensor.
Please check whether
the main wheel is stuck.
Please check whether
the main brush is stuck.
Please remove any
obstacles around the
vacuum-mop and try
again.
Please wipe the cliff
sensors clean and move
the vacuum-mop to a
new location to start.
Please place the
vacuum-mop on the
floor to start.
Please check whether
the side brush is stuck.
When the machine fails, the red indicator on the machine will blink
and relevant voice prompts will be heard.
Follow the voice prompts to resolve your problem.

VIOMI V3 Max Specifications