7
Section 4: Stand Installation
1. Open the package and take out the product with foam still attached. Gently place
it on a desktop or table.
2. Take out the stem and base. Insert the stem into the base opening and turn it
clockwise to lock in place. Then use the included screwdriver and one screw to
fasten base to the stem.
Opening
Stand
NO. 1 Screw
3. Attach the stand to monitor via the opening on the back. It should click into place.
Make sure the stand is securely attached to the back of the monitor then remove
the monitor from the remaining foam section and stand it up on the desired
surface.
Button
If needed, the stand can easily be detached from the monitor by pressing the
button on the back of the monitor just above the stand. Make sure the monitor is
laid on a at surface then press the button and pull the stand away to remove it.
To Next Page
Loading...
Need help?
General
