DVI Connector HDMI Connector DP Connector Audio Input AC IN Connector
Box Contents
1x Monitor
1x Power Cable (AC 100-240V 50/60Hz)
1x HDMI Cable
1x User manual
Basic Setup
1. Insert one end of the HDMI video cable into your PC's graphics card. DVI or DP
(display port) may also be used. These cables are not included.
Note: For opmal refresh rate (or "performance") at 100Hz, it is recommended to
use a DP (display port) or DVI-D dual link cable with the monitor's corresponding
connector
2. Connect the other end of the video cable to the corresponding connector on
your monitor. See the image below.
3. Connect the power cable to your monitor then connect the other end to your
power source such as a wall outlet or surge protector. It is recommended to
use a surge protector with adequate voltage if a wall outlet cannot be reached
directly.
4. Locate the power buon on the monitor and press it to turn the monitor on.
Note: If you cannot locate the power buon, please refer to the Control Panel
Secon on the next page.
AMD FreeSync™
If desired, you can use the monitor's AMD FreeSync™ feature. The feature itself is
on by default. In order to use this feature, please note you must have hardware
with AMD FreeSync™ capability, a DP, and the latest graphic drivers. To use this
feature, connect the appropriate cable to the DP connectors on both the computer
and the monitor. Aer connecng, you will receive a prompt to enable the feature
on your computer.
All specificaons and informaons are subject to change without noce.
-2-