Viotek GNV27DB2 User Manual

7
Section 4: Stand Installation
Keep the foam underneath the monitor before attaching the stand.
1. Open the package and take out the monitor with foam still attached. Gently place
it top-down on a desktop or table.
2. Take out the stem and base. Use the included screwdriver and one screw to
fasten base to the stem.
Screw x 1
Stand Stem
Base
3. Remove the foam covering the bottom of the monitor, then remove the adapter
from the back of monitor. Use two NO. 1 screws to fasten adapter onto the stem.
Adapter
Screws x 2
4. With the stand fully assembled, reattach it onto the back of monitor. Then remove
the remaining foam on monitor and stand it up on a at, level desktop or table.
Press the button to remove the monitor from the bracket if mounting.
Button
Make sure the monitor is laid on a at surface before removing the stand.

Viotek GNV27DB2 Specifications

General

Color	black
Screen Type	led
Wall Mount	75mm x 75mm
Webcam	no
OS Compatibility	windows, mac
Screen Size	27 inches
Panel Type	va
Aspect Ratio	16:9
Resolution	2560 x 1440
Native Resolution	2560 x 1440
Refresh Rate	144hz
Horizontal Viewing Angle	178 degrees
Vertical Viewing Angle	178 degrees
Response Time	1 milliseconds
Brightness	250 candela per square meter
Contrast Ratio	3000:1
Synchronization	freesync premium (amd adaptive sync), g-sync compatible (nvidia adaptive sync)
HDR	yes
Built-In Speakers	no
HDMI Ports	0
Height with Stand	17.8 inches
Width with Stand	24.26 inches
Net Weight without Stand	10.69 pounds