Viotek NBV24CB User Manual

7
Section 4: Stand Installation
1. Open the package and take out the product with foam still attached. Gently place
it on a desktop or table.
2. Take out the stem and base. Insert the stem into the base opening and turn it
clockwise to lock in place. Then use the included screwdriver and one screw to
fasten base to the stem.
Opening
Stand
NO. 1 Screw
3. Attach the stand to monitor via the opening on the back. It should click into place.
Make sure the stand is securely attached to the back of the monitor then remove
the monitor from the remaining foam section and stand it up on the desired
surface.
Button
If needed, the stand can easily be detached from the monitor by pressing the
button on the back of the monitor just above the stand. Make sure the monitor is
laid on a at surface then press the button and pull the stand away to remove it.

Viotek NBV24CB Specifications

General

Screen Type	led
Wall Mount	75mm x 75mm
OS Compatibility	mac, windows
Screen Size	24 inches
Panel Type	va
Aspect Ratio	16:9
Resolution	1920 x 1080
Native Resolution	1920 x 1080
Refresh Rate	75hz
Horizontal Viewing Angle	178 degrees
Vertical Viewing Angle	178 degrees
Response Time	8 milliseconds
Brightness	250 candela per square meter
Contrast Ratio	1, 000, 000:1
Synchronization	freesync (amd adaptive sync)
VGA Ports	1
Power Saving Mode	0.5 watts
Power Consumption	29 watts
Width with Stand	21.2 inches
Depth without Stand	8.2 inches
Height without Stand	16.3 inches
Net Weight without Stand	6.6 pounds