10
Section 7: Basic Operation
1. Insert one end of the DP cable into your PC’s graphics card. An HDMI cable may also be
used. HDMI cable not included.
2. Connect the other end of the cable to the corresponding connector on your monitor.
Audio Output
DP Connectors USB Port
HDMI Connectors Power Connector
3. Connect the power cable to your monitor then connect the other end to your power
source. It is recommended that you use a surge protector with adequate voltage if a wall
outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
VIOTEK Adaptive Sync
Adaptive sync eliminates image tearing, stuttering and ghosting by adjusting of a monitor’s
vertical refresh rate to the frame rate of the graphics card. It is compatible with GPUs that
use AMD® FreeSync™ or NVIDIA® G-Sync™. The feature is off on VIOTEK monitors by
default and must be manually enabled in the monitor’s OSD (see Section 9: OSD). To use
this feature, the connecting device must be compatible with adaptive sync (FreeSync and/or
G-Sync); have the latest graphic drivers; and be connected to the monitor using a DisplayPort
(DP) cable.
If you use HDMI to connect, you must use the HDMI 2.0 port to be able to use FreeSync.
Section 8: Indicator Light
Indicator light
Solid blue light indicates power is on and the monitor is operating normally. Flashing blue light
indicates no video source, no horizontal or vertical signal has been detected or power is low.
Please ensure your computer is on and all video cables are fully inserted and/or connected.
To Next Page
Loading...
Need help?
General
