Chapter 3 Digital Output Manual VIPA System SLIO
3-2 HB300E - SM - Rev. 09/38
VIPA 022-1BB00 - DO 2xDC 24V 0.5A
The electronic module accepts binary control signals from the central bus
system and transfers them to the process level via outputs.
It has 2 channels and their status is monitored via LEDs.
• 2 digital outputs, isolated to the backplane bus
• Status indication of the channels via LEDs
1
3
5
4
6
7
8
9
2
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
Locking lever terminal module
Labeling strip
Backplane bus
LED status indication
DC 24V power section supply
Electronic module
Terminal module
Locking lever electronic module
Terminal
LED Color Description
RUN green RUN MF
MF red
● ○
Bus communication is OK
Module status is OK
● ●
Bus communication is OK
Module status reports an error with
overload, short circuit or overheat
○ ●
Bus communication is not possible
Module status reports an error with
overload, short circuit or overheat
○ ○
Error at bus power supply
☼ ☼
Error in parameterization
(if parameterizable)
Status indication
RUN
MF
DO 0
DO 1
DO x green ● Digital output is set
on: ● off: ○ blinks with 2Hz: ☼
Description
Properties
Structure
To Next Page
Loading...
