Manual VIPA System SLIO Chapter 5 Analog Output
HB300E - SM - Rev. 09/38 5-19
VIPA 032-1BD40 - AO 4x12Bit 0(4)...20mA
The electronic module has 4 outputs with parameterizable functions.
The channels of the module are isolated to the backplane bus by means of
DC/DC converters.
• 4 analog inputs
• Suited for sensors with 0...20mA; 4...20mA
• 12bit resolution
1
3
5
4
6
7
8
9
2
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
Locking lever terminal module
Labeling strip
Backplane bus
LED status indication
DC 24V power section supply
Electronic module
Terminal module
Locking lever electronic module
Terminal
LED Color Description
RUN green RUN MF
MF red
● ○
Bus communication is OK
Module status is OK
● ●
Bus communication is OK
Module status reports an error
○ ●
Bus communication is not possible
Module status reports an error
○ ○
Error at bus power supply
☼ ☼
Error in parameterization
(if parameterizable)
Status indication
RUN
MF
AO 0
AO 1
AO 2
AO 3
AO x red ● Error channel x
- Overload, short-circuit
- Error in parameterization
- Wire-break
on: ● off: ○ blinks with 2Hz: ☼
Description
Properties
Structure
To Next Page
Loading...
