Viper 106V - Wiring Reference Guide

© 2004 directed electronics, inc.
9
wiring reference guide
NNOOTTEE::
Please remove all wire description tags from wiring after
connection to vehicle.
NNOOTTEE::
The current draw for the entire system is less than 9 mA. Power
supply voltage range is 9 to 16 volts. The current handling capacity for
each immobilisation circuit is 20amps continuous/30amps peak.
106V
BATTERY
FUSE BOX
+
-
TOUCH-KEY
3-PIN
GND1
GND2
+12V
FUEL PUMP
KEY ON

CUT
FUEL PUMP OUTPUT
FUEL PUMP INPUT
POWER HARNESS
TOUCH-KEY HARNESS
IMMOBILISER HARNESS
CONNECT TO 2
SEPARATE GROUNDS
FUEL PUMP (OPTIONAL)
GROUND BOTH OF THE
WIRES FROM THE 106V
IF NOT USED.
IGNITION
SWITCH

CUT
IGNITION
IGN: IGNITION SIDE
IGN: KEY SIDE

CUT
STR: KEY SIDE
STR: STARTER SIDE
STARTER