Viper 211HV - using your system; locking;arming

8
500-0092-01 (R1.0) © 2019 Directed. All rights reserved.
using your system
locking/arming
Pressing
AUX
AUX
for one second arms the system by activating the starter
kill (optional) and locking the doors (if connected). The horn will
honk (if connected and in audible mode, see “audible mode” on
page 10) and the parking lights will flash once to confirm arming
of the system. While the system is armed, the status LED will flash
once per second. The Failsafe
®
Starter Kill (if in stalled) will also
prevent the vehicle’s starter from cranking.
note: Manually locking the vehicle does not arm the
system; it will only lock the doors.
The system can also be programmed to arm the optional Failsafe
®
Starter Kill automatically (called Passive Mode). If the system has
been pro grammed for Passive Mode, the Failsafe
®
Starter Kill will
automatically activate 30 seconds after the ignition has been turned
off. After the ignition has been turned off, the status LED will flash
rapidly to indicate that the system is in Passive Mode.
If Passive Mode has been programmed on, then it is also possible
to program the system for Passive Locking. With Passive Locking,
the vehicle doors lock automatically at the same time that the Failsafe
®
Starter Kill is activated. If Passive Locking is programmed on, care
must be taken to prevent the keys from being locked in the vehicle.
note: For Passive Mode to be effective, the Failsafe®
Starter Kill relay must be installed.