12
© 2013 Directed. All rights reserved.
Government Regulations
This device complies with Part 15 of FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harm-
ful interference, and (2) This device must accept any interference re-
ceived, including interference that may cause undesirable operation.
This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and
can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television, which can be
determined by turning the equipment OFF and ON, the user is encour-
aged to try to correct the interference by one or more of the following
measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthat
to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for
help.
Remote Controls
To satisfy FCC RF exposure compliance requirements, this device
should be used in hand-held, hand operated configurations only. The
device and its antenna must maintain a separation distance of 20 cm
To Next Page
Loading...
