39
© 2009 Directed Electronics. All rights reserved.
3 PARKING LIGHTS—
CONSTANT
/FLASHING:
In the default setting, the parking lights will come on solidly for the entire
run duration. In the flashing setting, the parking lights will flash for the
entire run duration.
4 CRANK TIME—
0.6
/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 Sec-
onds:
If Feature 2 is programmed to the voltage sense setting, the crank time
must be set to the appropriate duration. The default setting is 0.6 sec-
ond. If a different crank time is desired, press the
button to ad-
vance through the LED Off settings. The unit will flash the LED to indicate
which time is selected. Once the 4.0 second setting is reached the next
press of the
button will reset the system to the shortest setting.
5 ACTIVATION PULSE COUNT—
1
/2/3 PULSES:
This feature allows the number of pulses to activate the remote start
feature to be changed from 1, 2, or 3 pulses. The pulse count pro-
grammed to start the vehicle will also be the same required to shut
down the remote start.
6 2nd—
IGNITION
/ACCESSORY OUTPUT:
This will allow the PINK/WHITE to be used as a 2
nd
ignition or a
2
nd
accessory.
7 ACCESSORY STATE DURING WAIT-TO-START—
OFF
/ON:
This will allow the programming of the accessory wire during the wait-
to-start period of a diesel motor. When ON the accessory comes on
when the wait-to-start timer is activated and stays on, dropping out
during crank and returning once the car has started. When OFF the
accessory will not activate during the wait-to-start period.
To Next Page
Loading...
