40
© 2009 Directed Electronics. All rights reserved.
8 2nd STATUS OUTPUT—
NORMAL
/LATCHED/PULSED:
If programmed to normal mode, this output turns on when the remote
start is activated. This output can be programmed as a Latched or
Pulsed output and can be used to activate the rear defroster when the
vehicle is remote started. When programmed to the latched output
the status only stays active for 10 minutes. When programmed to the
pulsed output the status sends out a single pulse. When programmed
for the latched or pulsed mode the output activates 10 seconds after
the remote start is running.
9 ANTI-GRIND
ON/OFF
:
With the anti-grind On (default) the ground-when-locked output will be
active during remote start operation. This activates an optional relay
and prevents the customer from re-cranking the car with the key, when
doing key takeover. If accessories such as a voice module or window
module are added to the unit, it may be necessary to use the two-honk
setting to program this feature OFF.
10 WAIT-TO-START TIME
OFF
/15, 30, 45 SECONDS:
The diesel wait-to-start timer default is in the OFF setting. When pro-
grammed ON the onboard timer can be set for 15, 30 or 45 sec-
onds.
11 RUN TIME (TIMER MODE)—12, 3, 6, 9 MINUTES: Selects the
time in minutes that the system will operate the engine when timer mode
activates the remote start. During the runtime the remote start can be
shut down with any of the shutdown inputs. Using the Bitwriter the run
time can be programmed for any duration from 1-16 minutes.
To Next Page
Loading...
