Viper 5601 - Impact Sensor Adjustment

32
© 2008 Directed Electronics. All rights reserved.
Access door
(Light Flash Fuse Jumper is under
access door - use needle nose pliers to
change fuse position)
➤ Impact Sensor Adjustment
Disarm system
Press/hold the
A U X
button of the remote control for 8 seconds or until the Amber
LED turns on and you hear one long beep.
Press/hold the
A U X
button 1.5 seconds or until the amber led comes on solid.
The control module emits one long chirp, confirming that it has entered adjust-
ment mode.
Press the
A U X
,
A U X
, or
A U X
buttons to adjust the sensor level.
Arm button: Pressing the
A U X
button increases the sensitivity one level. The siren
chirps twice confirming the sensitivity adjustment.
Disarm button: Pressing the
A U X
button decreases the sensitivity one level. The
siren chirps once confirming the sensitivity adjustment.
Remote Start button: Pressing the
A U X
button resets to default level 7. The siren
chirps three times.
To exit the shock sensor adjustment mode from the remote control: