38
© 2008 Directed Electronics. All rights reserved.
If the button is not released, the program jumps to the next menu and the siren
chirps twice. There are three possible menus. Select the menu you want, then
release the Valet/Program switch.
4. Select a Feature. Press and release the Valet/Program
switch the number of times corresponding to the feature you
wish to change. For example, to access the third feature,
press and release 3 times. Then press the button once more
and HOLD it. The siren chirps the number of times equal to
the feature you have accessed.
5. Program the Feature. While holding the Valet/Program
switch, you can toggle the feature on and off using the
remote control. Pressing the button that arms the system
selects the one- chirp or default setting. Pressing the button
that disarms the system selects the two-chirp setting.
6. Release. Valet/program switch.
Note:
Some features have more than two possible settings. Pressing
toggles through the two-chirp and higher settings.
Once a feature is programmed:
Other features can be programmed within the same menu•
Another menu can be selected•
The learn routine can be exited if programming is complete•
To access another feature in the same menu:
Press and release the Valet/Program switch the number of times necessary 1.
to advance from the feature you just programmed to the next one you want
to program.
Then press the Valet/Program switch once more and hold it. 2.
For example, if you just programmed the third feature in the menu and you want
to program the seventh feature in the menu, press and release the Valet/Program
switch four times and then press it once more and hold it. The siren chirps seven
To Next Page
Loading...
