Viper 5906V User Manual

12
© 2013 Directed. All rights reserved.
Basic commands (function level 1)
Arm
Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
lights flash once. The
ARMED
animation and beeps play to confirm. If
Valet mode* is On the doors lock and the
LOCKED (IN VALET)
anima-
tion and tone play. Exit Valet mode to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
Trigger Zone Fault report** plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds
the siren and flashes the lights. The
PANIC
animation and siren
tones play to confirm. Press the
or button to stop the out-
put.
AUX/Trunk
Press and hold
AUX
The Trunk opens (if connected) when this button is pressed for 2 sec-
onds. The
TRUNK RELEASE
animation and tones play to confirm.
* See “Remote and System Operations” on page 45 for details.
** See “Alarm Features” on page 35
for details.

Viper 5906V Specifications

General

Remote Start	Yes
Keyless Entry	Yes
Two-Way Remote	Yes
LCD Display	Yes
Number of Buttons on Remotes	5
Number of Remotes	2
Starter Kill	Yes
Dome Light Supervision	Yes
Panic Mode	Yes
Valet Mode	Yes
Range	1 mile
Shock Sensor	Yes
System Type	Security and Remote Start System
Alarm Features	Siren, Starter Kill, Shock Sensor