Operator’s Manual
Operating Procedure
15/50
2.1. T
ASKS OF THE TECHNICAL ASSISTANCE
/
NECESSARY EQUIPMENT
The following steps must be taken before any instrument service or maintenance.
a) TURN OFF THE POWER SWITCH ON THE RIGHT SIDE OF THE INSTRUMENT
b) UNPLUG THE INSTRUMENT FROM THE U.P.S. POWER SUPPLY OR POWER OUTLET TO GARANTY YOUR SAFETY
FROM ELECTRICAL AND MECHANICAL DANGER
FAILURE TO FOLLOW THE ADVICE AND INSTRUCTIONS IN THIS DOCUMENT RELEASE THE MANUFACTURER FROM ALL
LIABILITY AND MAY CAUSE INSTRUMENT DAMAGE.
NECESSARY EQUIPMENT / INSTRUMENTATION: ¡
T
OOLS REQUIRED FOR MAINTENANCE
:
Digital multimeter.
Harta STRIPT
Temperature sensor
Dye kit
Verification kit
Set of screwdrivers with cross head.
Set of Allen wrenches.
5.5 mm and 7 mm Socket wrenches.
Set of Open-ended spanners or wrenches (including 5.5mm and 5mm).
Circlips Pliers.
Tweezers.
RS232 to USB Converter.
[C
ODE
3050]
A
SSISTANCE
K
IT COMPOSED BY
:
[C
ODE
11400060] L
OCTITE
243 Thread locker (Medium-strength).
[C
ODE
12400040] Lubricant Spray WD-40 200ml.
[C
ODE
19900860] Special Allen wrench 2.5-3 mm T-Handle.
To Next Page
Loading...
Need help?
General