Viribus atb-e024-bk - Connecting Rear and Main Frames

5
Assembly
To see these instructions in video form, go to our YouTube channel
Viribus Bikes
and search
for “Fixed Gear Electric Tricycle”.
1. Connecting the Rear and Main Frames
1. Place the rear frame (1) and main frame (4) vertically on a rm level surface.
2. Loosen the 6 sets of M10 nuts and bolts on both sides of the frames, leaving slots between
the washers and the frames.
3. Align the slots of the frames with each other, sliding the rear frame onto the main frame as
shown. For best results, start with either side and repeat for the other side.
4. Partially tighten these nuts and bolts with your 17mm wrench. (Fully tighten them later after
chain installation.)