Vision Engineering Mantis Compact - MAINTENANCE & SPARE PARTS Mantis Compact; Replacing the Desiccant; Replacing the LED Array

MAINTENANCE & SPARE PARTSMantis Compact
Replacing the desiccant (see the diagram below):
u Disconnect the power cord from the back of the head.
u Remove the screw securing the desiccant cover and remove the cover u.
u Replace the desiccant and reinstall the cover.
u Reconnect the power cord at the back of the head.
Note: If the desiccant is pink it needs to be replaced. Useable desiccant is blue.
Replacing the LED array (see the diagram below):
u Disconnect the power cord from the back of the head.
u Remove the desiccant cover u (see Replacing the desiccant above).
u Remove the two screws that secure the array to remove the array v complete with the filters.
u Install the new array using the reverse of this procedure.
Note: Do not over tighten.
u Reconnect the power cord at the back of the head.
www.visioneng.com/support Mantis Service Manual
MAINTENANCE & SPARE PARTS
5
u
v
u
v
u
v