u Remove the lower head mounting bolt and then, ensuring the upper bolt is
tight, back it off 2 complete revolutions.
u Hang the head and tighten both head mounting bolts.
u Seat the rubber gaiter back into the groove in the head.
u Thread on the handle | and screw it in.
u Plug the mains adapter into the mains supply and connect the head power cable
into the head.
Mantis universal arm baseplate mounting dimensions
Mantis Service Manual www.visioneng.com/support
MAINTENANCE & SPARE PARTS
10
|
Mantis Universal Stand Baseplate (part number: 202-C-0050) mounting dimensions
Drawing not to scale. Dimensions for reference only.
75mm dia.
45 deg
45 deg
5.5mm dia.
3 places
To Next Page
Loading...
