6
2) The Basic Systems
The Mantis Stereo Viewing System is a powerful optical inspection system. The patented optical
technology provides a bright, crystal clear overhead image in a fatigue free viewing environment.
Long working distance offers ample room for rework and part rotation.
Mantis systems are available in two versions. One version is the boom mount (refer to page 3 of
this manual) which can be mounted on almost any table surface. This is good for general
inspection, viewing and rework, especially in a production environment. The other version is the
Mantis FX (refer to page 4 of this manual). This version has a portable stand that resembles a
traditional microscope stand. This version is better suited to off-line inspection.
Each Mantis system can be equipped with any two of the objective lenses listed below. It is
common to use a lower magnification lens (such as 2X or 4X) for general inspection and a
higher magnification lens (such as 8X or 10X) for closer inspection of possible defects.
Mantis - Boom Mount
Description Vision Engineering Inc. Part No.
1) Mantis viewing head M001
2) Mantis Boom Mount M003
Mantis FX - Bench Stand
Description Vision Engineering Inc. Part No.
1) Mantis viewing head M001
2) FX Bench Stand M002
Objectives - For use with either system
Description Vision Engineering Inc. Part No.
1) 2X Magnification Lens M222
2) 4X Magnification Lens M444
3) 6X Magnification Lens M004
4) 8X Magnification Lens M008
5) 10X Magnification Lens M009
6) 6X SLWD Magnification Lens M013
The 6X SLWD magnification lens has a much longer working distance than the standard 6X
magnification lens. It is specifically designed for rework applications.
To Next Page
Loading...
