Vision 1624 User Manual

Introduction 11
© 2019 Vision Engraving Systems
1.5 General Electrical and Facility Requirements
Machine Model
Requirements
Vision 1612, 1624, 2424 or 2448
One 110 VAC 15 Amp
OR One 220 VAC 10 Amp Single Phase
Optional Equipment
Engraving Chip Removal System
Required in addition to the machine power above:
One 110 VAC 15 Amp OR One 220 VAC 10 Amp
Optional Equipment Requiring
Compressed Air Supply
UNIST Misting System
NSK 50,000 RPM Spindle
Required in addition to the machine power above:
Clean Dry Compressed Air Supply 60 - 90 PSI
One 110 VAC 15 Amp OR One 220 VAC 10 Amp Single
Phase AND Clean Dry Compressed Air Supply 1 SCFM
@ 40 PSI
NOTE: In addition to the above requirements, a standard outlet is required for the computer.

Vision 1624 Specifications

General

Brand	Vision
Model	1624
Category	Engraver
Language	English