Vision 1624 User Manual

Vision Series 5 Controller User Manual94
© 2019 Vision Engraving Systems
The Measure Wizard window will open. The engraver will turn on its red dot laser pointer. Move the
spindle over the material and position the laser pointer so that it is in the upper left hand corner of the
engraving area you wish to define. Then, click on Next in the Measure Wizard window.
Move the laser pointer to the lower right corner of the engraving are you wish to define, then click on
Finish in the Measure Wizard window.

Vision 1624 Specifications

General

Brand	Vision
Model	1624
Category	Engraver
Language	English