VisionTrack VT2000 - Installation

11
INSTALLATION
Parkyourvehicleonaflatlevelsurface.
TurnofftheenginebeforeinstallingtheVT2000.
AttachtheVT2000usingtheprovideddoublesided3Mtape.
Thesurfacemustbecleananddrybeforeyouinstall.Werecommendedtoinstall
theproductbehindtherearviewmirroronthefrontwindshield.
NOTE:The3Madhesivetapewillnotstickwellwithdustoroil,etc.
Pleasemakesurethesurfaceiscleanbeforeapplying.
Adjustcameraview.Makesurethelenshasanunobstructedview.Checkfrom
outsidethevehicletocheckthecameraangle,youcanadjusttheangleviathe
bracketteeth.
Arrangethepowercordneatlyalongsideofthewindshieldanddoorpillartrim.
TheVT2000requiresacontinuous12/24voltpowersourcefromthevehicle.
ThecablesuppliedwillallowyoutohardwiretheVT2000unittothefuseboxof
yourvehicle.
Connectthe“redcable(+)”toafuse.Itshouldbeconnectedtoafusethathas
powerwhenyoustarttheengine.
Thegroundcableshouldbecontactedatthecarbodyorbatterynegative.
Startonthecarafterinstallation.