VisionTrack VT2000 - Page 9

9
FUNCTIONS
G‐SensorCalibration
1. Installtheunitandparkthevehicleonaflatsurface.
2. Turnontheunitandpressthesmallredbuttonthreeseconds.
3. Thencalibrationwillbedonewith“beep”sound.
Built‐inpowerbackup(SuperCapacitor)
Whenpowertotheunitisinterrupted,VT2000createsthelast
fileusingtheinternalSuperCapacitor.
TimeandDate
TherearenotimeanddatesettingsastheVT2000get’sthisinformationfromthe
GPSsatellite's.
SDMemoryCardFormat
Pleaseformat[initialize]theSDcardusingthe“ConfigurationToolVT2000”
software.
G‐SensorCalibrationisneededafterinstallingtheVT2000.
PoweroffvehicleandtakeoutSDmemorycard
TurnoffthepowerandthenchecktheBLUELEDlight.OncetheLEDlight
isnoton,youcannowsafelyremovetheSDmemorycard.
SafelyRemovalSDCard