Chapter 8: Data
DE5450S Remote Programmer Guide Rev. 8 59
1. Check the Send updated data immediately field, to automatically
update changed settings from the Remote Programmer to the control
panel.
Note: If the above field is not checked, the control panel will only be
updated when performing download table or full download.
2. In the Delay after acknowledge during download field, enter a time
value (in milliseconds) for a delay in sending commands. This field
should be used when problems in communication is experienced.
3. In the Download Code field, if a value (four hexadecimal digits) is
entered, the Remote Programmer uses this value instead of the value in
the site information field when performing login.
Note: If no value is entered in this field, then login is performed using the
download code in the site information table.
Note: For additional use of the download code see Chapter 9: Two
Download codes.
8.2 Using Customized Full Upload/Download Data
Note: The following section applies to PowerMax+ only.
This feature enables selecting only specific data to be uploaded/downloaded in
connection with the control panel. This saves significant time in
uploading/downloading data.
1. Check the Enable customizing Full Upload/Download Data field, to
enable uploading/downloading of customized settings.
2. Mark the relevant check boxes to specify the data to be uploaded to the
control panel.
Attention: Use the exact same customized fields for both uploading and
downloading in order to prevent inconsistency in the data.
Note: Click the Next/Prev buttons to see all the available fields.
Note: When X-10 Device Settings and PGM are selected, the scheduler
becomes functional (see chapter 6, for further details).
To Next Page
Loading...