™
Page 5
49.0
SD-EUR87dB
3.1 Performing a remote antenna SD reset
Connect the transmitter to the service to be identied, place the antenna on the red
cable as previously described with the label pointing away from the transmitter.
Press the "i"
button. The screen will change to something similar to the below.
0
SD
Press the "Enter" button as indicated by the "SD" icon. The screen will then
revert to the one below with an arrow pointing forward, indicating that the reset was
successful.
53.1
SD-EUR95dB
The system is now ready to identify the cable at the location of the interest.
Note that the SD reset will revert to the default setting if the
vLoc3 is switched off.
NOTE
To Next Page
Loading...
Need help?
General
