Vivint — User Guide
- 63 -
l
Off
l
On
Quick Bypass
Normally sensors that are open at the time the system is armed will require force bypassing by entering your
User Code. The system can be set so a User Code is not required to bypass open sensors when the system is
armed.
l
Off
l
On
Quick Exit
The Quick Exit option allows you to start the Exit Delay while the system is armed. This allows you to leave the
premises without having to disarm and rearm the system.
When the Quick Exit option is on, a Quick Exit button will display on the security screen. Press the button to start
the Exit Delay.
After Quick Exit, the system will fully re‐arm in the mode that it was in before (Stay or Away Mode).
l
Off
l
On
Auto Un-bypass
Normally, sensors manually bypassed with the User Toolbox will automatically have their bypasses removed
when the system is disarmed. The system can be set so sensors that have been manually bypassed will stay
bypassed until the bypass is manually removed.
l
Off
l
On
Auto Stay
The Auto Stay option will change the arming mode if no one exits after arming the system in Away Mode. When
the system is armed in the Away Mode the Exit Delay will begin.
With the Auto Stay option on, if a designated exit/entry door does not open and close during the Exit Delay, the
system will arm in the Stay Mode instead of the Away Mode.
l
Off
l
On
To Next Page
Loading...