Vivint — User Guide
- 64 -
Key Fob Arm/Disarm Sound
The system can be set so when it’s armed or disarmed by a wireless key fob, a beep will sound through the
internal and external sounders to indicate that the key fob’s signal was received.
This helps in installations where the Control Panel is not visible or there are no other system status indications at
the key fob’s location.
l
Off
l
On
Key Fob Disarm After Sound
The system can be set so when it’s disarmed with a wireless key fob after an alarm has occurred, a special
series of beeps will sound through the internal and external sounders.
This option serves as an alert to warn you to approach the premises with caution as an intruder may still be
present.
l
Off
l
On
IMPORTANT: The system can be set so when it’s disarmed with a wireless key fob after an alarm
has occurred, a special series of beeps will sound through the internal and external sounders. This
option serves as an alert to warn you to approach the premises with caution as an intruder may still
be present.
Key Fob Options
The installer selects which options are enabled for each key fob (1‐8) used with the system.
Refer to the table below for the options selected for your key fobs:
Key Fob Arming Bypass Options
Options - All Key Pads
l
Auto‐bypass all open perimeter sensors and un‐bypass a sensor if closed while the system is armed
l
Auto‐bypass open perimeter sensors permanently while armed
l
Allow key fob arming only when all perimeter sensors are closed
To Next Page
Loading...