Vivint SkyControl - Cleaning the Touchscreen Display

System Customization and Tools 29
To configure the brightness and volume
1. AttheHomescreen,pressSettings.
2. PressPanel Settings.
3. Toconfigurethevolume,presstheVolumebutton,adjustthevolumetoyourdesired
level,andthenpressOK.
4. Toconfigurethebrightness,presstheDisplay Brightnessbutton,adjustthebrightness
toyourdesiredlevel,andthenpressOK.
Thevolumesettingdoesnotaffectthealarmsoundervolume.
Adjusting the Display Backlight Timeout
Thepanelbacklighttimeoutsetsthelengthoftimethatthedisplaystayslitafteruse.Youcanadjust
thebacklightto30seconds,1,2,5,or10minutes,ortoAlwaysOn(tolightthedisplayatalltimes).
NOTE:Toconservethepanel’sbackupbattery,duringaninputpowerfailure,thedis-
playgoesdarkafter30secondsregardlessofthissetting.
To configure the display backlight timeout
1. AttheHomescreen,pressSettings.
2. PressPanel Settings.
3. PresstheDisplay Timeoutbutton,selectthetimeperiodyouwant,andthenpressOK.
Cleaning the Touchscreen Display
Thereisaspecialoptionforthepanelthatenablesyoutocleanthetouchscreendisplay.Theoption
locksthedisplayfor30secondssoitcanbecleanedwithoutsensinganybuttonpresses.Cleanthe
displaywithadry,softcloth.
To lock the touchscreen display for cleaning
1. AttheHomescreen,pressSettings.
2. PressPanel Settings.
3. PresstheScreen Cleaning Mode Activatebutton.Thecleaningscreenappearsfor30
seconds.Itshowsthetimeremaining.Thetouchscreenislockedduringthistime.