VIVOTEK
User's Manual - 7
Installation
Removing Dome Cover
First, follow the instructions below to remove the dome cover. Flip the black retention tabs
in the counter-clockwise direction to release the dome cover (clockwise if you look from the
bottom up.)
Record the MAC address before
installing the camera.
Network Camera
Model No: FD8131
Made in Taiwan
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pat. 6,930,709
MAC:0002D1730202
R o HS
Dome Cover
Then remove the black cover as shown below.
Tilt Adjustment Screw
To Next Page
Loading...
Need help?
General
