Vivotek FD8173-H - Hardware Reset

VIVOTEK
User's Manual - 9
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
Micro SD/SDHC Card Capacity
This network camera is compliant with Micro SD/SDHC 8/16/32/64GB and other preceding
standard SD cards�
Recessed Reset
Button
LED Denitions
Item LED status Description Priority
LED De`nitions
1 Steady Red Powered and system booting 3
Red LED off Power off
2 Steady Red Network failed 2
Red LED blinks every 1 sec�
(on for 1 sec� and off for
antoher)
Connected to network (heartbeat) and BRB
mode (Back Recovery Booting)
3 Blinks RED every 0�15 sec�
(on for 0�15 sec� and off for
another)
Upgrading rmware. 1
4 Blinks RED every 0�15 sec�
(on for 0�15 sec� and off for
another)
Restoring defaults� 1