Vivotek SD8333-E - Page 188

VIVOTEK
188 - User's Manual
priority 0, 1, 2 1 6/6 Indicate the priority of this event:
“0” = low priority
“1” = normal priority
“2” = high priority
delay 1~999 10 6/6 Delay in seconds before detecting the
next event.
trigger boot,
di,
motion,
seq,
recnotify,
volalarm,
vi
vadp
boot 6/6 Indicate the trigger condition:
“boot” = System boot
“di”= Digital input
“motion” = Video motion detection
“seq” = Periodic condition
“recnotify” = Recording notification.
“volalarm” = Audio detection.
“vi” = Virtual input.
“vadp” = VADP trigger
triggerstatus String[40] trigger 6/6 The status for event trigger
exttriggerstatus String[40] <blank> 6/6 The status for event trigger
exttriggerstatus1 String[40] <blank> 6/6 The status for event trigger
exttriggerstatus2 String[40] <blank> 6/6 The status for event trigger
exttriggerstatus3 String[40] <blank> 6/6 The status for event trigger
di 0~15 1 6/6 Indicate the source id of di trigger.
This field is required when trigger
condition is “di”.
One bit represents one digital input. The
LSB indicates DI 0.
mdwin 0~7 0 6/6 Indicate the source window id of motion
detection.
This field is required when trigger
condition is “md”.
One bit represents one window.
The LSB indicates the 1
st
window.
For example, to detect the 1
st
and 3
rd
windows, set mdwin as 5.
mdwin0 0~7 0 6/6 Similar to mdwin. The parameter takes
effect when profile 1 of motion detection
is enabled.
valevel <boolean> 0 6/6 Enable/Disable audio detect.
valevel0 <boolean> 0 6/6 Enable/Disable audio detect profile.