VIZIO 60HZ E SERIES User Manual
39
Version 3/16/2010 www.VIZIO.com
Adjusting the TV Settings
If you did not set up your HDTV for DTV / TV channels using the Initial
Setup screens or if your setup has changed, you can do so from the TV
menu.
Press MENU key to bring up the OSD menu, the default option is TV.
Select it by pressing either the OK key
The following options are available in the TV menu:
1. Input
- This option allows to
select the input, it being either
DTV/TV, A/V, Component,
HDMI1, HDMI2, HDMI3, HDMI4,
RGB and PHOTO.
2.
Channels - This option allows to select the type of signal input, it
being either antenna signal (over the air) or direct cable service (no
a set-top box).
3.
Menu Language - This option allows selecting the language to
which it is preferred to have the OSD menu and instructions
available to you.
4.
Date & Time – Allows adjusting the displayed time and date.
5. PC Settings – If the selected input is connected through RGB
(computer being used), this option allows adjusting of display to
accommodate the signal content.
Adjusting the Picture Settings
When viewing DTV / TV or an HDMI, Component, or AV source, the
following picture adjustment OSD screens are available when you
press MENU on the remote control.
Press ▲ / ▼ / ◄ / ► to highlight and select the choice, then press OK
key to select the desired adjustment, and then press the EXIT key
when finished making adjustments.
To Next Page
Loading...
Need help?
General
