The TV displays
“Please Scan Channels!”
• Ensure your antenna or cable/satellite box is connected to the TV.
• Select the input to which your antenna or cable/satellite box is connected.
• Perform a channel scan. Press MENU, then select TV > Channels > Scan Channels > On.
I cannot return to
the Setup App.
• The on-screen menu has guided setup. Press MENU, then select Help > System Reset >
Start Setup Wizard. Enter your PIN (default is 0000). Select Yes.
There are black/gray
bars on the top/bottom/
sides of the picture.
• Set the TV to Wide or Zoom Mode. Press MENU, then select Wide. Highlight Wide or Zoom and press OK.
• Adjust the video settings of your external device (Blu-ray
™
or DVD player).
• If using the RGB (computer) input, ensure you are using a supported desktop resolution.
• Some television channels add black bars to the picture.
The TV does not respond
when I press buttons
on the remote control.
• Insert new batteries into the remote.
• Point the remote directly at the TV’s sensor.
• Ensure nothing is blocking the TV’s sensor. (The sensor is on the front of the TV, in the lower right corner.)
The TV displays “No Signal”
• Ensure your connected devices are turned on.
• Press the INPUT button on the remote and select the input to which your device is connected (HDMI,
Composite, etc).
• If connected to a cable/satellite service with a set-top box via coaxial cable, press the TV button on the remote,
then use the Number Pad to change the channel to 3 or 4.
To Next Page
