VIZIO VOJ320F1A User Manual
Version 8/25/2008 31
www.VIZIO.com
Chapter 3 Setting Up to Watch Television
For ‘Preparing Your LCD HDTV for Wall Mounting’, see page 8.
3.1 Basic LCD HDTV Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the HDTV, and then plug the
power cord into an AC wall socket.
2. Connect Audio and Video Cables to the HDTV
(see Chapter 2 for detailed steps)
3. Turning Power On
Once all the components are connected, press the Power ON button on the side of the HDTV, or
press the Power ON (Orange) button on the remote control.
4. Initial Setup
After powering on the TV set, the Initial
Setup screen will come up; please press
the
button on the remote control.
The Language choice screen will be
displayed; the default English option is
highlighted. If you wish to change the
OSD language to Español or Français,
press the button on the remote control
to select the language you want.
Press the
button on the remote to go
to the next screen.
Note: At this point, if a Set-Top Box from your
Local Cable or Satellite Service Company or other
equipment is been used; please press the LAST
key on the remote control and skip to Step 5. If
this is not your case, please continue at Step b.
a. The Tuner screen will be
displayed; default choice is
Antenna. If you are using Cable
(No Box) Service, press the
button on the remote control to
highlight CABLE.
Press the
button on the remote to go to the next screen.
To Next Page
Loading...
Need help?
General
