VIZIO VOJ320F1A User Manual
Version 8/25/2008 7
www.VIZIO.com
TV Setup and Stand Assembly
Note: We strongly recommend that two people perform the setup and assembly due to the weight and
size of the TV.
To unpack the TV and stand base:
1. Remove the remote control, batteries, and power cord from the foam end caps.
2. Remove the two top foam end caps.
3. Remove the stand base under foam end cap.
4. Remove the TV from the box and lay it face down on a clean, flat surface.
Note: Make sure that the surface is free of debris to prevent the TV screen from getting scratched.
To attach the TV stand base:
Note: If you will be wall mounting the TV, skip this step
and go to the next page for wall mounting instructions.
1. Line up the arrows on the stand neck (attached to
the TV) with the arrows on the stand base.
2. Push the stand base onto the stand neck.
3. On the bottom of the base, insert the four included
screws and tighten.
4. Move the TV into an upright position.
Stand Neck
Stand Base
To Next Page
Loading...
Need help?
General
