2. Allow a few minutes for the air system to vent pressure and for
the oil to drain back to the tank, then check the oil level through
the sight-glass on the compressor tank. Oil level must be
checked with the vehicle in a level position, not on a slope. If the
oil level is low, add compressor oil until the correct level is
reached.
3. Check the hydraulic oil to ensure that it is not low; add hydraulic
oil until the correct level is reached.
Display Box Messages
System Check
The display will show:
VMAC – WWW.VMACAIR.COM
Both red and green lights will flash.
The display will show:
SYSTEM CHECK / SYSTEM READY
The system will go to the Ready State.
Ready State
The display will scroll through the following messages:
VMAC
PH# 250 740 3200
HRS:XXXX:XX
If the system is due for a 500 hr service, it will display:
HRS:XXXX:XX 500S
Additional possible messages:
WARM HYD OIL
If the hydraulic oil temperature is below +5 F(–15 C).
CHECK AIR FILTER
Every 100 hrs the system will remind the operator.
To Next Page
Loading...
