VMAC – Vehicle Mounted Air Compressors
Toll Free: 1-800-738-8622
Fax: 1-250-740-3201
5
□ Remove any small brackets that locate hoses and wiring in the
front upper engine sector.
□ Remove the OEM L-brackets securing the coolant expansion
bottle hose to the cross-member under the engine.
□ Remove the two steel fuel lines from the fuel filter that connect to
the cylinder head and to the injection pump. Cap the openings
immediately to prevent contamination.
□ Remove the fuel filter assembly from the engine, including the
bolt that clamps the oil fill tube. Store the fuel filter upright in a
clean place to prevent fuel loss and contamination.
□ Loosen the two lower oil fill tube mounting bolts.
□ Clean excess paint and dirt from the engine where the fuel filter
was mounted.
□ Remove the fan.
□ Clean the inside of the crankshaft pulley and remove the bolts
securing it to the harmonic balancer. Do not rotate the
crankshaft pulley as this may cause engine imbalance.
□ Place the crank pulley adaptor spacer on the rear of the VR
crank pulley with the lip on the pulley sitting correctly in the
recess of the adaptor. Align the holes.
□ Position the pulley and adapter on the front of the harmonic
balancer with the pins in two of the crankshaft bolt holes.
□ Place the OEM crank pulley bolt ring plate on the front of the VR
crank pulley.
□ Apply Loctite to the supplied M10 x 100 mm bolts, thread them
into the pulley holes and torque them to specifications.
To Next Page
Loading...
