4342
VX4 User manual V1.0VX4 User manual V1.0
ENGLISH
STORAGE
ATTENTION:
Your device requires some rules during storage, proceed as follows:
• Charge the li-ion battery to approx. 60 % before storage.
• Store the e-scooter at a temperature between 5° C - 40° C
(41° F - 104° F).
• Repeat the procedure at least every four weeks during storage
and when not in use to avoid deep discharge.
• Protect your e-scooter from dust and other external influences,
ideally in the stored original packaging.
• When you are not riding the scooter, store it in a covered dry
and cool place. Do not park the scooter outdoors for long
periods of time. Excessive sunlight as well as overheating and
undercooling of the tires will accelerate their aging process
and adversely affect the service life of the scooter and its
battery pack.
• There is no warranty claim for damage to the li-ion battery due
to improper storage or insufficient charging during storage or
non-use (deep discharge).
ATTENTION:
Your device requires regular and careful maintenance.
Proceed as follows:
• Your e-scooter is not waterproof. The electronic components are
protected against strong jets of water within the specified test
framework in accordance with the IPX6 standard. This does not
rule out the possibility of water penetrating the inside of the
scooter. For this reason, it is important that the e-scooter is
regularly cared for and serviced as required.
• Disconnect the e-scooter, if connected, from the charger and
switch it off.
• Check your device for loose parts, damage, excessive wear and
the integrity of the housing and tires. If you find any defects
during the inspection, stop using the e-scooter and contact your
dealer.
• Check the tire pressure regularly (at least every month).
The recommended tire pressure varies between 2.5 and 3.0 bar
depending on the rider weight. For riders weighing 50 kg or
more, we recommend a tire pressure of 2.5 bar. For riders weig-
hing 100 kg or more, we recommend a tire pressure of 3.0 bar.
PLEASE NOTE:
• Therefore, use a damp rag for maintenance and avoid contact
of water with electronic components in any case.
• Dry the device completely, before each start-up or loading.
MAINTENANCE AND CARE
To Next Page
Loading...
