5150
VX4 User manual V1.0VX4 User manual V1.0
ENGLISH
BEFORE THE FIRST RIDE
Make sure that the device is in perfect and undamaged condition.
• Place the e-scooter on a flat surface and check the charging
status of your device.
• Press the on / off button on the handlebar, the display with the
battery indicator lights up.
• Stand directly next to your e-scooter and hold the handlebars
firmly with both hands.
• Place your right or left foot on the footboard and push off with
the other foot. Now also place the second foot behind or next to
the first foot on the footboard and press the accelerator.
• To brake or stop, you can press the brake lever on the handle-
bars.
• To switch off the e-scooter, press and hold the on / off
button for 4 seconds.
ATTENTION! For safety reasons, the scooter will not start until you
push off lightly with your foot from the ground as described previ-
ously.
ADJUSTMENTS
Brake adjustment drum brake
If you turn the nut clockwise, the braking force of
the drum brake is increased. If you turn the nut
counterclockwise, the braking force is weakened.
Fine adjustment handlebar
and folding mechanism
If you feel that the handlebar is a little loose, first
tighten the four screws that secure the steering
head with the Allen wrench included in the package.
Other screws are located on the folding mechanism
and on the lower end of the handlebar. If you feel
that the folding mechanism has some „play“ or that
it does not engage or close correctly, you can ad-
just these screws. This requires good tuning, as the
mechanism should have no „play“, but should open
smoothly by lifting the safety latch.
ATTENTION! Since this e-scooter has a total per-
missible mass of 150kg, the brakes are adjusted to
the maximum load at the factory. Therefore, please
be careful during commissioning and the first bra-
ke tests and adjust the drum brake to your needs
if necessary.
To Next Page
Loading...
