14 Attendant Features
Attendant Speed Dial - System Storing
System Speed numbers must be entered by the first programmed
Attendant. If an Attendant is not specified, enter at Station 100.
1. Press SPEED, then press the desired outside line key,
-or-
Press SPEED + SPEED to select an outside line automatically.
2. Dial the System Speed bin location (9020-9099).
3. Dial telephone number, press SPEED, then hang up.
Speed Dial Options
To use the following speed dial options, enter as shown:
Initiate a Pulse-To-Tone
Switchover
Press TRANS during number entry.
Insert a Pause Press HOLD during number entry.
Insert a Flash into Speed Number Press FLASH.
Insert a Non-Display Character Press TRANS as first entry in speed bin.
This causes the numbers stored in the
bin not to display on the Digital
Telephones when the bin is accessed.
NOTE … Speed Bin numbers 9060-9099 are not monitored by Toll Restriction.
To Next Page
Loading...
