Intercom 51
» The CALLED station can place the current CO call on hold by
pressing the HOLD button,
-or-
They can place the current intercom call on hold by pressing
the HOLD button. The intercom call is placed on hold on the
available intercom button.
» The CALLED station then presses the flashing intercom
button to answer incoming intercom call. When answered,
the following message displays on the called station LCD:
Sta XXX can be a programmed station name.
SINGLE LINE TELEPHONE
Not applicable
Intercom Calls
To place an Intercom Call:
1. Press the pre-programmed DSS button of the party to be
called, or dial the extension number.
(You will hear ringing if the called station is in the T mode; or
three bursts of tone if called station is in H or P mode.)
2. Lift the handset, or use speakerphone after tone bursts stop.
3. Hang up to end the call.
CALL FROM STA XXX
MMM DD YY HH:MM am
Dialing a number in the numbering plan
activates the telephone automatically.
To Next Page
Loading...
