Voith BTS-Ex - Page 20

BTS
-Ex, non-contacting thermal switch unit
Safety
Installation and Operating Manual / Version 7 / 3626-019600ex en / Protection class
0: public / 2020-07-15
20
Electric shock:
DANGER
Electrostatic processes
Electrostatic charging may injure persons by an
electric shock.
•
Allow only a qualified electrician to install the equipment into which the turbo
coupling is installed.
•
The unit and the electrical installation are provided with ground connections.
Working on the turbo coupling:
WARNING
Risk of
injury
While working on the turbo coupling, there is the risk of injury through cutting,
crushing, burns and cold burns in case of minus degrees.
•
Please observe the installation and operating manual of the turbo coupling!
•
Never touch the turbo coupling without wearing protective gloves.
•
Start to work on the turbo coupling only after it has cooled down.
•
Ensure that there is sufficient light, a sufficiently large working space and
good ventilation when working on the turbo coupling.
•
Switch off the unit in
which the turbo coupling is installed and secure the
switch against inadvertent switch-on.
•
For all work performed on the turbo coupling ensure that both the drive motor
and the driven machine have stopped running and that unintended starting is
absolutely impossible!
Noise:
WARNING
Hearing loss, permanent impairment of hearing
The turbo coupling generates noise during operation. If
the A-
classified
equivalent sound pressure level L
PA, 1m
exceeds 80 dB(A), this may cause
impairment of hearing!
•
Wear ear protection.
Sound pressure
level

cover sheet of
operating manual of
turbo coupling