Intended use of the lead battery tester
includes:
- Determination of battery status for a 12 V motor vehicle battery to
at least 36 Ah with a running measurement (with 100 A).
- running voltage measurement (uncharged) on running engine
- battery voltage measurement (tester load switch turned off)
during ignition
- charge measurements on batteries with ignition on or running
engine or attached battery charger are not permitted
- measurement under adverse conditions is not permitted. Adverse
conditions are:
- strong precipitation such as rain shower or snow
- moisture or high atmospheric humidity (e.g. fog)
- dust and combustible gasses, vapors (gasoline, diesel or bat-
tery acid) or solvents
- thunderstorms or storm conditions like strong electrostatic fields
etc.
Another use than described above is not permitted and leads to the
damage of this product. Beyond that there is a risk of hazards, e.g.
short-circuit, fire, electrical shock etc. The entire product may not
be changed and/or converted! The safety instructions are to be
strictly observed!
18
To Next Page
Loading...
