Safety instructions
Illustration (open side)
1. Brackets for battery clamps (pole pliers)
2. Cooling holes for power shunt
3. LED lights with colours red for "BAD”
yellow for "WEAK” i.e. threshold or green
for "GOOD”
4. 3-digit LED display max. display value 999
5. Button "LOAD” to start automatic measuring process
6. Pole plier black for minus pole (-) of battery
7. Button to set cold start current value (CCA) of battery
8. Pole plier red for plus pole (+) of battery
Caution!
Observe maximum input values.
Contents list
Introduction ....................................................................................17
Intended use ..................................................................................18
Adjustable components (end side) ................................................19
List of contents ..............................................................................19
Safety instructions ..........................................................................20
Use of lead battery tester ..............................................................22
Measurement procedure ................................................................22
Disposal ..........................................................................................27
Reasons for Error Messages ..........................................................27
Maintenance ..................................................................................27
Technical Data and Measuring Tolerances ....................................28
19
To Next Page
Loading...
Need help?
General
